Covering a Weedhopper surfaces with Stits

This may or may not work in your browser. Short movie
of me flying my "B" Model Weedhopper .

The Sub fin getting the
trim tape applied.
The more I did, the less
sloppy it became.

The start of the Stits process

The Sub fin before getting
tightened with the iron.

The Sub fin after it
was tightened with the iron

The last piece of the tail
feathers that I did.
Notice how much cleaner
it looks

All of the tail feathers are
done and ready to have
Poly Brush sprayed on.
I will wait and do all the
spraying at one time.

Next the wing will get the
ribs mounted and then
covered.
It should be a lot easier then
those little pieces of the tail.

Home

Best viewed in Internet Explorer